User Manual; Safety Instructions; General Guidelines - Velleman CAMCOLMS1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of
the device after its lifecycle could harm the environment. Do not
dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling
service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, don't
install or use it and contact your dealer.

2. Safety Instructions

The white LEDs which illuminate the microscope target field are very
bright. Do not stare directly into these LEDs as it may damage your
eyes.
The clear plastic distance shell sometimes picks up dirt or toxic material
from a microscopically observed surface. Be careful that this doesn't get
in contact with the human skin. Always wash carefully or disinfect as
needed.

3. General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages
of this manual.
The microscope is not waterproof, so keep it dry.
Do not use it in a humid place like bathrooms. A dry environment will
maintain its life to maximum.
Use the microscope only between -5C° and 50°C.
Sudden temperature change may form dew inside the microscope. Put it
inside a handbag or plastic bag to slowdown temperature changes.
Do not point Microscope lens to the sun or strong light for a long time.
Powerful light may hurt the light-sensitive electronics.
Avoid touching the lens.
Do not unplug the microscope from USB port when LEDs are on. This
may cause information loss or circuit damage. Please always close the
MicroCapture software and then unplug the microscope.
V. 02 – 25/01/2013
CAMCOLMS1

USER MANUAL

3
©Velleman nv

Publicité

Table des Matières
loading

Table des Matières