Operation; Before Straightening; Filling The Water Tank - Silk-n GoBrush Mist Mode D'emploi

6. Operation

EN
• Clean all parts of the steam brush straightener before
• Before using the steam brush straightener for the first

6.1 Before straightening

• The hair should be clean, dry and free of styling products
(except special products that promote hair straightening).
• Thoroughly comb the hair so that there are no knots in it.
• Separate your hair into horizontal sections. Each section should
be around the width and thickness of a heating plate
Pin or clip the sections you are not working on out of the way.

6.2 Filling the water tank

The optional steam feature ensures gentle hair straightening for
silkier and shinier hair. Fill the water tank only when you intend to
use the steam feature.
Use only distilled water to fill the water tank. Otherwise,
limescale may form inside the steam brush straightener
and shorten the product lifespan.
1. Fill the fill bottle
cap at the tip.
2. Open the rubber closure
3. Guide the tip of the fill bottle into the opening on the water tank.
4. Gently squeeze the fill bottle so that water runs into the water
tank.
5. When the water tank is full (approx. 12 ml), remove the fill
bottle from the water tank and replace the rubber closure to
close the opening.
6. Wipe dry any spilled water on the steam brush straightener
with a soft cloth.
The steam brush straightener is now ready for the steam feature.
13
first use as described in the chapter "Cleaning".
time, switch it on for a few minutes and set it to the
highest temperature. As a result of the manufacturing
process, you may notice a slight odour. This is normal
and only occurs during first use. Ensure that the room
is well ventilated.
with distilled water and remove the small
5
on the water tank
8
.
1
.
7