Door Glass Replacement - Napoleon S20-1 Manuel D'installation Et D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.5

door glass replacement

WARNING
!
Do not use substitute materials.
Glass may be hot. Do not touch glass until cooled.
Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
1. When the appliance is cool, have two people remove the door and place it face down on a soft, non-abrasive
surface (see "door removal" section). Be careful not to scratch the paint.
2. Remove the 6 screws securing the glass retainers (Fig. 7-1). Set the screws and glass retainers aside.
3. Remove all broken glass and the old gasket.
4. Apply high temperature silicone (not supplied) in the gasket groove as illustrated (Fig. 7-2).
5. Cut the 1/4" gasket (supplied) to size and place on top of the silicone. Press the gasket down firmly to ensure
it stays in place. Ensure the gasket joint is at the bottom as illustrated (Fig. 7-2).
6. Place new glass on top of the gasket.
7. Re-secure the 6 glass retainers by installing the 6 screws previously removed in step 2 (Fig. 7-3). Ensure the
retainer dimples face away from the glass.
8. Re-install the door.
Old
Gasket
Broken
Glass
High Temperature
Glass
Retainer
New 1/4"
Fig. 7-1
New
Glass
maintenance
38.1
Silicone
Gasket
Gasket Joint
Dimple
Fig. 7-3
W415-2796 / D / 05.07.21
EN
Fig. 7-2
33

Publicité

Table des Matières
loading

Table des Matières