Function Buttons - AGA marvel AELTTDW Manuel D'utilisation Et D'entretien

Function Buttons

The combination of high temperatures and dishwasher detergent may cause damage to some items if they
are washed in the dishwasher. Remember, if there is any doubt about any aspect concerning items to be
washed in the dishwasher, follow the instructions from the manufacturer of the items, or wash the items by
hand.
On/Off Button (1)
Turn the dishwasher on with the On/Off button. When you press the On/Off button, the indi-
cator lights illuminate the display for ON position. The lights will turn off in the OFF position.
Program Selection /Cancel Button (2)
P
Press this button until the desired program appears in the indicator. To cancel the program,
open the door, press and hold the Program Selection/Cancel button for 3 seconds. After
Cancel 3*
the 3-2-1 countdown, 0:01 is displayed. Close the door and wait for the draining process
to complete. Draining is completed in 2 minutes and the dishwasher will give an electronic
beep when completed.
Function
If you press any of the Function buttons, (F1, F2, F3, F4), during program selection or time
delay selection, an electric beep will be heard provided that the function is supported by the
selected program. To cancel the selected function, keep the function button pressed until
the indicator is no longer illuminated.
Half Load Function (F1)
F1
If you want to run your machine without loading it completely, place your dishes into the
machine as you desire. Press On/Off button to turn on your machine. Select desired program
WARNING
and press the Half Load Function button (F1). The Half Load Indicator lights up on the
display, close the door of your machine to start the program. With the Half Load option you
can use every part of your lower and upper baskets and save water and energy.
Sanitize Function (F2)
F2
Sanitize function raises the water temperature in the final rinse to meet the requirements of
NSF/ANSI STANDARD 184 for Residential Dishwashers. Certified residential dishwashers
are not intended for licensed food establishments.
Available only with Regular Wash, Pots & Pans, and Pots & Pans Plus programs.
Select desired program and press the Sanitize Function button (F2). The F2 button will light
DANGER
up on the display, close the door to start the program
At the end of a successful sanitization, "S" is displayed. The "S" will not be displayed if the
cycle is interrupted or the water could not be heated to the reuired temperature.
NOTE: Only sanitizing cycles have been designed to meet the requirements of 6 for soil
removal and sanitization efficiency. There is no intention, either directly or indirectly, that all
cycles have passed sanitization performance tests.
CAUTION
NOTICE
OPERATING THE DISHWASHER
Do not try to remove the Intense Wash impeller!
13