Configuring The Network - Siemens Gigaset SE361 WLAN Guide D'installation Rapide

Quick Start Guide

Configuring the network

Before the PCs can communicate with the Gigaset SE361 WLAN and with each other
in a local network, you must change their network settings. This will normally be the
case if you are using the default settings. To find out how to do this, read the section
entitled "Configuring the local network" in the detailed user guide on the CD. First
connect just one PC. You can then carry out the basic Gigaset SE361 WLAN configu-
ration. After that you can connect further PCs.
Configuring the Gigaset SE361 WLAN
You now need to make a few configuration settings so that you can use your Gigaset
SE361 WLAN to operate a local network and establish a connection to the Internet.
The Gigaset SE361 WLAN provides a user interface which you can access with a Web
browser. Carry out the following steps:
ì
Launch the Web browser on your PC.
ì
Enter the IP address of the Gigaset SE361 WLAN in the browser's address field:
http://192.168.2.1
A Web screen appears for you to enter a password. The default password on
delivery is admin.
ì
Enter the password and click OK.
Note:
For security reasons, you should change the password later (please refer to the
user guide on the CD that comes with the device).
A page containing security information is displayed.
ì
Click on OK.
The start screen now appears.
On this screen, you can change the language for the user interface (see user
guide on the CD). During the initial configuration the default language is Ger-
man (if the Web browser is also set to German) or English (for all other lan-
guages).
ì
Click on Basic Setup Wizard.
ì
Confirm the welcome screen with Next >.
ì
Select your current location. You can make the settings for the clock to change
automatically to summer time and/or to the time zone as you wish.
ì
Confirm your entry with Next >.
24