Laserworld Diode Série Mode D'emploi page 9

Manual: Diode Series
8. Zoom (not available for FB4 version)
Use the Zoom-X / Zoom-Y knobs to change the pattern size on the X resp. Y axis.
9. Modes / Functions (not available for FB4 version)
The modes can be selected by the ‚MODE' button below the LED display. Use the ‚UP' or
‚DOWN' buttons to set the DMX address and press ‚DIR' to select the requested mode or
confirm the DMX address (see below).
• Automatic mode (Auto) / Animation mode (Anil)
Select this mode by pressing the MODE button until ‚Auto' is displayed and confirm by
pressing DIR. Now the laser device projects patterns / graphics in random order
• Music mode (Aud1)
Select this mode by pressing the MODE button until ‚Aud1' is displayed and confirm by
pressing DIR. Control the sensitivity of the microphone by the SOUND trim pot at the
rear side of the device. The LED is flashing when the device is triggered.
• DMX mode (D001)
Change the DMX address by using the UP and/or DOWN buttons and confirm the DMX
address by pressing the DIR button. By pressing the UP or DOWN buttons for 3 seconds,
the DMX values increases / decreases in intervals of +/- 10. The DMX mode only works
when a DMX controller is connected to the laser.
The laser uses 12 DMX channels, which are explained in the following table.
Channel
1 Mode Select
2 Pattern selection
3 Strobe
4 X-axis movement
page 9 / 40
Value
0 - 63
64 - 127
128 - 159
160 - 191
192 - 255
0 - 87
88 - 253
254 - 255
0
1 - 255
0
1 - 167
168 - 188
189 - 209
210 - 254
255
Function
Laser off
Music mode
Auto mode (beam patterns)
Auto mode (graphics)
DMX mode
Graphics patterns
Beam patterns
Laser off
no strobe
Strobe (fast to slow)
no movement
manual positioning / offset
movement left to right (slow to fast)
movement right to left
movement left to right
no movement