Laserworld Diode Série Mode D'emploi page 11

Manual: Diode Series
Channel
12 Color
Please note that not each pattern can be combined with each effect.
• ILDA control
Connect your device („ILDA IN") via an ILDA cable to an interface / controller. ILDA mode
starts immediately. Use a laser control software, e.g. Laserworld Showeditor, to run the
device. Use „ILDA OUT" to connect it to another device.
• Master-Slave-Mode (Slav)
To use the daisy chain / Master-Slave-Mode connect two (or more) laser projectors of the
same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
Master projector
Select auto or music mode
at the master projector
(see above)
10. Turn device off
To turn off the device switch it off („OFF"), turn the key ‚OFF' and disconnect the power
cable from the mains.
page 11 / 40
Value
0 - 19
20 - 39
40 - 59
60 - 79
80 - 99
100 - 119
120 - 138
139 - 164
165 - 248
249 - 254
255
DMX cable
Function
white
red
green
blue
yellow
purple
cyan
multi-color
changing multi-color (fast to slow)
changing multi-color 2
multi-color 2 (no red)
Slave projector
To use this mode, please press the
MODE button until the display shows
SLAV and confirm by pressing DIR.