Application - Imetec Bellissima E6506 Mode D'emploi

EN
• When creating the hairstyle, be careful not to bring the
air styler close to sensitive parts of the face, ears, neck
or skin.
• After use, allow the air styler to cool down completely
before putting it away.
PREPARING THE HAIR
• Wash the hair as usual and comb it while removing any
knots.
• Dry the hair, leaving it slightly damp.
OPERATION
This styler works with air, which means it works according to
the same principle of a common hair dryer: the hot air comes
out from the main body and passes through the holes of the
accessories.
When using the styler or while it is heating or cooling, place
the appliance on a smooth and heat resistant surface.
Choose the desired accessory and apply it as shown in the
ILLUSTRATIvE GUIDE. Connect the air styler to the mains.
ACCESSORIES
Concentrator (6): use this accessory immediately after
washing your hair to remove excess moisture.
Curling tong (7)
Use this accessory to create tight curls.
• Take a thin lock of hair between your fingers; the thinner
the lock, the tighter the curls.
• Act on the lever of the clamp and insert the tip of hair
between the cylinder and the clamp itself.
• Release the clamp and wrap the strand around the tong.
• Switch the air styler on.
• Wait for the lock to dry as desired before removing it from
the tong by releasing the clamp.
• Move along the curl with your hands.
Round brush (8-9)
Use this accessory to create soft waves and curls.
• Take a thin lock of hair between your fingers, the same
width as the brush.
• Wrap the lock of hair around the brush no more than twice.
• Set the air styler at the maximum temperature.
• Wait for the lock to dry as desired before releasing it from
the brush.

APPLICATION

12