Do % Saturation / Do Mg/L Display; Connecting Peripherals; Probes (Ph/Conductivity/Do); Protective Rubber Boot - EIJKELKAMP 18.52.01 Manuel D'instructions

HI & LO Alarm limits
13
14 Temperature reading & units
1.5.6

DO % saturation / DO mg/L Display

Only available on 18.52.01.
# Description
1 Measurement mode (%DO or DO)
2 Appears when the reading is stable
3 Appears when the reading is on hold
4 Reading & Units
5 Temperature compensation mode
6 Alarm indicator
7 Calibrated points
%DO: Barometric pressure
8
mg/L: Salinity value (ppt)
9 HI & LO Alarm limits
10 Temperature reading & units
1.6

Connecting Peripherals

1.6.1

Probes (pH/Conductivity/DO)

Conductivity Probe with
built in temperature
sensor (8-pin
Connector)
Depending on the meter you have,
the following probes can be connected:
Meter
18.50.01
18.52.01
1.6.2

Protective Rubber Boot

1. Removing rubber boot: Disconnect the electrodes. Push the meter from the
bottom edge out of the rubber boot.
2. Replacing rubber boot: Slide the meter in from the top, than push the
bottom down until it clicks in.
pH / ISE (BNC)
●
●
1
10
9
8
Conductivity (8-pin)
●
●
9
2
pH/ mV/ ISE Probe
(BNC)
DO Probe with built
in temperature
sensor (6-pin
Connector)
DO (6-pin)
●
Removing / Replacing boot
3
4
5
6
7