Mounting And Removing The Display; Power On/Off - Yamaha Batavus Guide D'utilisation

Lever
Handle bar
Power switch
49

6.3 Mounting and removing the display

Display
To mount the display, press the lever on the holder while sliding
the display towards the rear of the bicycle into the holder, until you
Holder
hear a click. To remove the display, press the lever while sliding
the display towards the front of the bicycle out of the holder.
TIP
Recommended display mount angle is 0°-5° from ground line.
(Adjust the display mount angle by loosening the display holder
bolt. The angle depends on each rider.)
Ground line
Do not remove it while riding.
Make sure the display is turned off before mounting or removing it.

6.4 Power on/off

Each time you press the power switch, the power switches between
"On" and "Off".
When you turn on the power, all of the displays light up. After that,
the battery capacity indicator, speedometer, assist power meter,
the function display such as average bicycle speed, and "STD" of
assist mode indicator, and clock and thermometer are displayed.
TIP
• When you turn on the power, the assist mode is automatically
set to Standard mode.
• Keep your feet off the pedals when turning on the display
unit. Also, do not start riding immediately after turning on the
display unit. Doing so could weaken the assist power.
(Weak assist power in either of these cases is not a
malfunction.) If you did either of the above by accident, remove
your feet from the pedals, turn on the power again, and wait a
moment (approximately two seconds) before starting to ride.