Technical Label; Transport And Installation; Transport; Installation - BAT Screeny 110 Manuel D'utilisation Et D'entretien

Use and maintenance manual
MOTOR
Type
Specifications
(*) The total weight refers to maximum size of the awning with fabric not including gear or motor.
(**) Values referred to the product fully extended.
For those configurations that are not in the table, please refer to the project drawing.
The product's dimensional tolerances comply with EN13561 provision.
For the specifications of the optional accessories, see Ch.Pt.9 "Optional",
instructions.
· The resistance to pooling water is tested with an inclination of 25%; retract the awning during rain if
the angle is less than this.
· The maximum load permitted for non-retractable parts is 800 Pa.

6.2 Technical label

The "technical label", which is on the inside cover of this manual, specifies the year in which the CE marking, the
manufacturer's data and the specific product data were applied.
7

Transport and Installation

7.1 Transport

Transport and shipping shall be borne by the reseller and/or the manufacturer, who shall transport the product
using adequate packages to protect it up until its delivery to the final customer.
Any damage to the product sustained during removal and subsequent handling and/or transport,
performed after the initial installation, is not covered by warranty.
The packaging material must be disposed off and/or recycled according to the applicable local legislation.

7.2 Installation

·Assembly of the components, installation and first start of the product must only be performed by
specialised and qualified technicians, and is the responsibility of the reseller and/or manufacturer.
· It is recommended to use protective gloves so as not to damage the blinds.
All the instructions and the main safety standards to perform these operations are described in the "Assembly
Manual" and the "Installer Manual".
The position chosen by the user for the installation of the product must provide adequate support as well as the
space necessary for the structure to open fully (see "Installer Manual").
8

Disassembly and Disposal

· The product must be removed and disassembled by trained and qualified personnel, in compliance
with health and safety legislation. Request specialist assistance from Technical Support.
Operations must be performed with the product completely closed.
Cut the power supply to the system by disconnecting the circuit that supplies the switch, disconnect the motor,
open the support brackets and remove the structure from them.
No materials considered hazardous have been used in the product; there are no particular instructions for its
disposal or scrapping.
Follow applicable legislation in force when the product is removed for its disposal.
09/09/2019 Rev.09
Screeny 110 Line
see manual for installed motor
CE marking, approved for sun awnings
P. 32 and the corresponding
31