Intended Use And Installation Location - BAT Screeny 110 Manuel D'utilisation Et D'entretien

Screeny 110 Line
4

Intended use and installation location

The product is designed to protect against solar radiation and possibly to limit reverberation in the space below it.
Users of the product must be adults.
Improper use of the product shall release the Manufacturer from any liability from damage or injuries which might
result.
Failure to respect the indicated conditions of use shall invalidate any and all warranties provided by the
manufacturer.
The product, once installed, is intended only to perform raising or lowering of the fabric in order to reach the
maximum opening and closing positions, as well as the intermediate ones if required.
· Before making the product operational, read Ch.Pt.2 "Safety", P. 23 and Ch.Pt.4 "Intended use
and installation location", P. 26 carefully.
· Ensure there is nobody obstructing or excessively close to the product's moving parts when opening
and closing.
· Pay attention to all the warnings applied to the product, and follow all safety regulations and
instructions for use.
· Any use other than those indicated above is forbidden, as different conditions of use could create
risks to the user and other persons nearby.
· It is strictly prohibited to climb on or hang/place any objects from/on the product.
· The product must always be opened from top to bottom and never vice versa, as it could break with
the risk of serious personal injuries.
· Never wind or lever the awning wound-up when the fabric is wet, to prevent the formation of mould
and structural damage (if it continues to rain, close the awning, then open it again as soon as possible
to let it dry).
· Close the product completely in the event bad weather or snow.
· The operation of the product with snow on the fabric or in freezing temperatures could damage it.
· The formation of condensation on the fabric should not be considered a defect; it is a natural
phenomenon.
Manual product
The product is opened and closed by a rod attached to a manual crank.
Motorized product
The product can be opened and closed via:
· a SWITCH installed near the product in a position providing the user full visibility of the same during its movement.
If installed outdoors, the switch must have appropriate ingress protection.
· A REMOTE CONTROL, portable or wall mounted.
The minimum installation height of the product should comply with applicable legislation; if fitted, the opening/
closing switch must be installed in a protected position, at a minimum, legal height from the ground and in an area
which is not dangerous to access.
Pic. 8 OPENING: Fabric stretched
to its maximum extension.
26
Pic. 9 STOP: Stop of the move-
ment.
Use and maintenance manual
Pic. 10 CLOSURE: Fabric wrapped
around roller tube.
Rev.09 09/09/2019