Maintenance; Troubleshooting Table - BAT Screeny 110 Manuel D'utilisation Et D'entretien

Use and maintenance manual
See the instructions provided in the remote control manual annexed.
· Use a lockable (key) switch if the structure is to be installed in sensitive locations such as schools,
colleges, hospitals, rest homes etc.
· If the product is fitted with a remote control, this must be kept out of the reach of children.
The remote control may also be used outdoors, as long as the system has an IP rating of IP55 or higher.
The space made available during the installation must take into account the space required for the movement
and allow the product to open fully.
· No ladders or other fixed objects must be installed or positioned near the product, such that the
spaces it needed are reduced.
The characteristics and operation of these systems are described in the manuals, which are supplied as annexes,
for the requested controls, motor and automatic devices.
In the event of faults or malfunctions, contact your reseller.
5

Maintenance

· MAINTENANCE ON ELECTRICAL PARTS MUST ONLY BE PERFORMED BY QUALIFIED
PERSONNEL
· All maintenance and cleaning operations must be performed with the electrical supply disconnected.
·There is the danger of deadly electrical charges over the course of the research or of the restoration
of potential mulfunctions in the electrical part.
· Before operating the structure, read instructions in Ch.Pt.2 "Safety", P. 23 carefully.
· The operations of assembly of the components, installation and first start of the product must only
be performed by specialised and qualified technicians, and is the responsibility of the reseller and/or
manufacturer.

5.1 Troubleshooting Table

· All safety requirements must be followed in the event of faults or troubleshooting.
For faults and errors not listed in the following tables, contact Technical Support.
MANUAL AWNING
PROBLEM
Fabric does not roll up evenly (forms
cone)
The product jerks when opening, jams
and movement is noisy
The terminal does not lower, or jerks
when lowering
The fabric is not evenly taut
The product jerks when opening, jams
and movement is noisy
MOTORISED AWNING
PROBLEM
Fabric does not roll up evenly (forms
cone)
Squeaking noise during movement of
the product
09/09/2019 Rev.09
CAUSES
Structure out of square
Gust of wind
Structure out of square
Check that there are no obstacles
preventing the terminal from sliding
Structure out of square
The Zip has come out
Structure out of square
Check that there are no obstacles
preventing the terminal from sliding
CAUSES
Structure out of square
Gust of wind
Impurities/obstructions in moving parts
Structure out of square
Screeny 110 Line
SOLUTIONS
Contact Technical Support
Unroll the fabric and eliminate any folds
Contact Technical Support
Remove any obstacles
Contact Technical Support
Contact Technical Support
Contact Technical Support
Remove any obstacles
SOLUTIONS
Contact Technical Support
Unroll the fabric and eliminate any folds
Clean and lubricate any moving parts
Contact Technical Support
27