Krups EA 82 Série Mode D'emploi page 74

Problem
The coffee grinder
makes a strange
noise.
The grinder setting
button (13) is diffi-
cult to turn.
No steam comes
out of the steam
nozzle (21).
There is not enough
frothed milk.
The frothed milk is
not thick enough.
The auto-cappuc-
cino accessory (op-
tional) does not
suck up the milk.
After filling the water
tank (10), the war-
ning message re-
mains displayed on
the screen.
The cleaning or des-
caling programme
will not start.
KRUPS Espresseria Automatic Premium
Probable causes
Foreign particles are inside the grin-
der.
Has the grinder setting button been
moved when grinding was not taking
place ?
The nozzle or the nozzle support is
blocked.
The type of water used may not be
suitable initially for making steam (a hi-
gher calcium content may be needed).
Check that steam is coming out of
the nozzle.
Check if the small air inlet in the
upper part of the nozzle is blocked.
Check if the two ends of the small
stainless steel tube are connected to
the steam nozzle.
Check that the accessories are
connected correctly to one another
and that they are not blocked.
The water tank is not fitted correctly.
The float at the bottom of the tank
does not move freely.
The water tank is scaled.
Programme error.
Use and maintenance / SERIE EA 82xx
Corrective actions
 Contact KRUPS Customer
Service.
 Only turn the setting button
during grinding.
 Remove the steam nozzle
from its support and unblock
these two parts using the clea-
ning wire.
 Empty the tank and remove
the Claris filter.
 Fill the tank with mineral water
high in calcium (> 100 mg/litre),
it may take as many as 5 to 10
cycles of steam to achieve a
continuous jet of steam. Once
you have a continuous jet of
steam you should not have to
use this particular type of water
again.
 Unblock the steam nozzle with
the cleaning wire.
 Unblock the inlet, dry it and if
necessary rinse it with water.
 We recommend using very
fresh pasteurised or UHT milk.
 Correct the position of the
stainless steel tube.
 Connect the accessories cor-
rectly to one another and un-
block them if needed.
 Fit the water tank correctly.
 Rinse the water tank under
water and descale if required.
 Unplug the appliance then
plug it back in and switch it on.
Restart the programme.
33