Supplementary Notes - Klarstein THERMAXX Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Temperature setting

1. Press the temperature key, activate ∧/∨ to adjust temperature, the indicator light

at the center of the temperature key is highlighted, the temperature is displayed by

three-digit digital tube, the first two digits display the temperature, the second digit

with the "dot" of digital tube displays "°C".

2. The default temperature is 24 °C, set the temperature by press ∧/∨ button,

automatically confirm after 5 seconds without operation or directly press the

temperature button to confirm (the temperature setting range is 7-35 °C).

3. When the machine is on, long press the temperature button for 5 seconds, and the

Celsius mode (point + C) is converted to the Fahrenheit mode (point +F). When the

machine is in Fahrenheit mode, long press the temperature button for 5 seconds to

switch back to Celsius mode.

4. In Fahrenheit mode, the default temperature is 75 °F and the setting range is 45-

95 °F

5. Degrees Celsius and Fahrenheit mode has memory function and can remember the

previous mode even after complete power failure.

Controlling the heater through control panel: if the highest 35 °C is already set, then still

press "up", will go to 7 °C,just a cycle.

If you control through App, at this situation, press the "up", there are no reflect, always

35 °C, only can "down" it.

Frost prevention function

1. In standby mode, when the probe temperature is below 5 °C (41°F), mid-range

heating will be automatically started;

2. When the probe temperature is higher than 7 °C (45°F), stop heating and return to

standby state.

3. When frost protection is activated, the power indicator flashes at a frequency of 2

seconds per time and the digital tube displays the current temperature (Celsius or

Fahrenheit).