Pleasant Hearth LI-24 Directives D'installation Et D'utilisation page 9

OPERATING INSTRUCTION
The log set control functions can be accessed in two (2) ways:
• Using the control panel buttons, located on the lower right-hand corner of the log set.
• Using the multifunction remote control unit.
The log set conveniently features separate controls for flame effect and for heater control.
This allows you to operate the unit in two (2) different modes:
• As a full-featured log set - both flame effect and heater are on.This mode allows you to enjoy the
look of the fire along with the heat output of a heater.
• As a visual effect - only the flame effect is on, the heater is off. We recommend this mode for
warm weather application, when you want the ambiance of a fire, without any heat output.
Figure 3
1
Main Power Button:
This button supplies power to all the functions of the log set. The Main power button must be in
the ON position, either from the remote or controls on the log set for the functions to work.
2
Heater Control Button:
This button controls the heater ON/OFF and 5 temperature modes from Low to High. When the
heater is first turned on, it will come on at the lowest room temperature setting. The log set will
remember the last heat setting and in later use the heater will start at that setting, unless power
to the unit has been interrupted. Each time the Temperature button is pressed, the temperature
set point increases, allowing you to adjust the ambient temperature.
3
Flame Control button:
This button controls the brightness of the flame effect with settings at High, Medium and Low.
When the log set is first turned on, the flame will come on at the highest setting. The log set will
remember the last flame setting used and in later use the flame brightness will start at that set-
ting, unless power to the unit has been interrupted. Each time the Flame button is pressed, the
flame brightness decreases. The only way to turn off the flame effect completely is to turn off the
Main Power button.
3
2
9
1