Tyco SMD-429 PG2 Serie Instructions D'installation Et D'utilisation page 10

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
WARNING! To comply with FCC and IC RF exposure compliance requirements, the device should be located at a distance
of at least 20 cm from all persons during normal operation. The antennas used for this product must not be co-located or
operated in conjunction with any other antenna or transmitter.
Avertissement! Le dispositif doit être placé à une distance d'au moins 20 cm à partir de toutes les personnes au cours de
son fonctionnement normal. Les antennes utilisées pour ce produit ne doivent pas être situés ou exploités conjointement
avec une autre antenne ou transmetteur.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential install-
ation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Re-orient the receiving antenna
l
Relocate the alarm control with respect to the receiver
l
Move the alarm control away from the receiver
l
Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits.
l
Consult the dealer r or an experienced radio/television technician for help.
l
WARNING! Changes or modifications to this equipment not expressly approved by the party responsible for compliance
(Visonic Ltd.) could void the user's authority to operate the equipment.
Notified Body BSI (2797)
EN14604: 2005/AC:2008
Visonic Ltd., Tel-Aviv, Israel.
2019
Smoke Alarm Device
2797-CPR-713754
Hereby, Visonic Ltd. declares that the radio equipment type SMD-429 PG2 is in compliance with Directive
2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
sonic.com/download-center.
http://www.vi-

Publicité

Table des Matières
loading

Produits Connexes pour Tyco SMD-429 PG2 Serie

Ce manuel est également adapté pour:

Visonic smd-429 pg2 serie

Table des Matières