Know Your Water Pump - Briggs & Stratton 073000 Manuel D'utilisation

KNOW YOUR WATER PUMP

KNOW YOUR WATER PUMP
Read this Operator's Manual and safety rules before operating your water pump.
Compare the illustrations with your water pump, to familiarize yourself with the locations of various controls
and adjustments. Save this manual for future reference.
Priming Plug
Discharge Outlet
Suction Inlet
Pump Chamber
Water Drain Plug
Serial Number Label
Air Cleaner — Protects engine by filtering dust and
debris out of intake air.
Choke Lever — Used when starting a cold engine.
Discharge Outlet — Connect discharge hose here.
Engine Label — Provides model, type and code
number of engine. Please have these readily available
when calling for assistance.
Fuel Tank — Capacity of 10 fl. oz..
Oil Fill Cap/Dipstick — Check and fill engine with oil
here.
Primer Bulb — Prepares a cold engine for starting.
Priming Plug — Fill pump with water here to prime
pump before starting.
Stop Switch
Throttle Lever
Starter Handle
5
Choke Lever
Air Cleaner
Pump Chamber — Be sure to fill with water before
starting.
Starter Handle — Used to start the engine.
Stop Switch — Push to "Stop" to switch off engine.
Serial Number Label — Provides model, revision and
serial number of water pump. Please have these
readily available when calling for assistance.
Strainer Basket (not shown) — Used to limit
passage of abrasive materials into the pump.
Suction Inlet — Connect reinforced suction hose here.
Throttle Lever — Used to adjust engine speed to
control pump output.
Water Drain Plug — Remove to drain water from
pump and flush internal components with clean water.
Primer Bulb
Engine Label
Oil Fill Cap/Dipstick
Fuel Tank