Progress PDV6075B Notice D'utilisation page 20

20 progress
Controls
The hood is fitted with a control panel with aspiration speed selection control and a light
switch to control cooking area lights.
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended
that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave
in operation during cooking and for another 15 minutes approximately after terminating
cooking.
The control switches are located on the unit's front panel:
T7
T1 Button Speed (power) of suction 1
T2 Button Speed (power) of suction 2
T3 Button Speed (power) of suction 3
T4 Button ON/OFF Speed (power) of
suction 4
Note: The Speed (power) of suction 4
remains in function for 5 minutes, then
the it returns to the previous setting.
T5 Button for filter saturation control
T6 Button OFF speed
Button for control panel activation­
deactivation
T7 Button ON/OFF lights
Button for activation/deactivation of
charcoal filter saturation control
Delayed switch-off function for the
suction speed (power):
Select the desired speed and press the
same button again for more than 2 sec.;
the button flashes to indicate that the
function has been activated. Press again to
deactivate the function.
The selected speed will turn off after:
Speed (power) of suction 1: 20 minutes
Speed (power) of suction 2: 15 minutes
Speed (power) of suction 3: 10 minutes
Speed (power) of suction 4: 5 minutes
T6 T1 T2 T3
Function Activation – Deactivation
control panel
Press the T6 button for more than 5
seconds
Function Activation – Deactivation
control of charcoal filter saturation
With the hood off press the
more than 5 seconds.
Button T5 flashes:
Twice to indicate that the saturation control
for the charcoal filter has been activated
Once to indicate that the saturation control
for the charcoal filter has been deactivated
Function of filter saturation control and
reset
At regular intervals, depending on how
long the hood is used, the button
to indicate that it is necessary to carry out
the maintenance of the filters according to
instructions in the related paragraphs.
Button T5 lights up with steady light: it is
necessary to perform maintenance on the
grease filter
Button T5 lights up flashing: it is necessary
to perform maintenance on the charcoal
filter.
Reset filter saturation indicator:
With the hood off press the
more than 2 sec.
Repet the operation if necessary.
T4 T5
T7 button for
T5 lights
T5 button for