Connecting Power And Interface Cables - Seagate DAT Drive DDS Manuel D'installation

Seagate DAT Drive Installation Manual—English

Connecting power and interface cables

Attach the power and SCSI interface cables to the
appropriate connectors on the back of the drive. Figure 6
shows the locations of these connections.
Connecting the SCSI interface cable
Turn off all power to the drive and host computer. Attach the
SCSI cable, making sure to align pin 1 on the cable with pin 1
on the drive. Pin 1 on the SCSI connector is to your right as
you look at the back of the drive (see Figure 6). Your SCSI
cable should have pin 1 highlighted by a colored stripe.
Connecting the power cable
Attach an 4-pin power connector from the system power
supply to the connector on the back of the drive. The
recommended 4-pin power connector for the internal drive is
an AMP 1-48024-0 housing with AMP 60617-1 pins or
equivalent.
Figure 6
Locations of SCSI interface and power connectors on
internal drive
4-pin
power
connector
SCSI pin 1
SCSI connector
A-15