Silverline 103597 Mode D'emploi page 8

GB
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
Troubleshooting
Problem
No power
During use the welder stops
working
Poor weld
8
Possible cause
Mains circuit breaker operated or fuse blown
Internal fuse blown
Duty cycle exceeded and Over-Heat Indicator (6)
is illuminated
Incorrect current setting
Wrong electrode rod/stick
Poor earth connection on workpiece
Solution
Check circuit is capable of required current then reset mains circuit
Have fuse replaced by a qualified electrician
Leave the welder for 20-30 minutes to cool down
Adjust Current Dial (3)
Replace electrode rod/stick
Check Earth Clamp (8). Ensure there is no grease, paint or other
surface coating that would cause a bad electrical connection with
the workpiece