Know Your Product; Operation - SPARKY GUR 10.8Li HD Notice Originale

press the ON/OFF trigger switch (5).
3 = Battery 100% - 60% charged.
2 = Battery 60% - 30% charged.
1 = Battery < 30% charged. It is necessary to re-
charge the battery.
The direction of decreasing the charge level indi-
cated by the LEDs is marked on the housing of
the power tool.
VII - Know your product
Before using the power tool, familiarize yourself
with all operating features and safety require-
ments.
Use the tool and accessories only for the applica-
tions intended. All other applications are expressly
ruled out.
1. Locking sleeve
2. Bit holder
3. LED work light
4. LED battery indicator
5. ON/OFF trigger switch
6. Forward reverse switch
7. Battery release buttons
8. Battery
9. LED charge state indicator
10. Charger
VIII - Operation
LED WORK AREA LIGHT
The machine is equipped with LED light (3) to il-
luminate the work area and improve visibility when
drilling in areas with insufficient light. The LED light
is on until the ON/OFF switch (5) is pressed.
REVERSING
The extreme position of lever (6) to the right
(viewed from the rear) is equivalent to anti-clock-
wise rotation, the extreme position to the left - to
clockwise rotation. When the ON/OFF switch (5) is
depressed lever (6) can not be actuated. (Fig. 1)
WARNING: Reversing can be per-
formed only when the spindle is not rotating!
Drilling and tightening screws are performed with
lever in extreme position to the left. Removal of
8
EN
pages-GUR 10,8Li.indd 8
screws is performed with lever in extreme position
to the right.
SWITCHING ON - SWITCHING OFF
Switching on: press ON/OFF switch (5).
Switching off: release ON/OFF switch (5).
The power tool is equipped with a brake. The
spindle stops rotating immediately after releasing
the switch lever.
SMOOTH ELECTRONIC RPM CONTROL
Light pressure on ON/OFF trigger switch (5) re-
sults in low rotation speed, further pressing the
switch results in smooth increase of the rpm to
maximum upon reaching the extreme position.
WARNING: The continuous operation
of the electronic control may overload or dam-
age the regulator.
OPERATING THE TOOL
Impact operation starts automatically when the
load exceeds certain level. Pushing the trigger
switch at no load will result only in change of
speed.
The fastening torque depends on the duration
of impact operation. Generally, maximum torque
is achieved after 6 to 10 seconds of impact op-
eration. Further operation will result only in slight
torque increase. Prolonged impact operation may
cause motor damage or burning.
The torque depends on the length, grade and
diameter of the screw. It depends also on the
strength of material to be fastened (wood, metal,
etc.) and the type of washer used. Operate the tool
after calculating the appropriate impact operation
time by performing a trial fastening and measuring
the actually achieved torque by a torque wrench.
The torque depends on the length, grade and di-
ameter of the screw. It depends also on the rigid-
ness of material to be fastened (wood, metal, etc.)
and the type of washer used. Operate the tool after
calculating the appropriate impact operation time
by performing a trial fastening and measuring the
actually achieved torque by a torque wrench.
WARNING: Power tool with a faulty
switch is dangerous and shall be repaired be-
fore use.
GUR 10.8Li HD
4.11.2011 . 10:13:58 .