Tuning Into A Preset Station; Alarm Setting - CAPTELEC PCR-2228 Mode D'emploi

R 2228 / PCR-2228
Note 1: The current station and also the current volume level will be memorized when the radio is turned off.
Once you turn on the radio again, the memorized station will be broadcasted at the memorized volume level.
Note 2: For the best FM reception, extend the FM antenna wire to its full length and vary the direction to
capture the strongest signal. Do not connect the FM antenna wire to an outdoor antenna.
PRESETTING YOUR FAVOURITE STATION
You can preset up to 10 FM stations. These 10 presets are shown as preset numbers F01, F02, F03, F04, F05, F06,
F07, F08, F09 and F10.
1. In radio mode, follow step 4 in "Radio Operation" and tune to the station that you wish to preset.
2. Press and hold the TIME SET/PRO button (2) for more than 2 seconds until the last memorized preset number
appears and flashes.
3. You can then choose the preset number that you want to memorize this station by pressing the HOUR/TU-
button (3) or the MIN/TU+ button (4) to adjust the number.
4. Once the preset number is chosen, it will keep flashing for 8 seconds. Press TIME SET/PRO button (2) once
within these 8 seconds to save the station to the chosen preset number. The LED display will stop flashing
and change back to show the frequency.
5. If the TIME SET/PRO button (2) is not pressed within this 8 seconds period, then the LED display will jump
back to show frequency, and the memory storing will not succeed.
6. If the chosen preset number is already memorized with a station, the above procedure will allow the newly
tuned station to overwrite the originally memorized station.

TUNING INTO A PRESET STATION

1. When the radio is on, press the TIME SET/PRO button (2) once. The radio will be tuned to the next preset
station from the last used preset number. The preset number will be shown for 2 seconds, then the LED
display will change to show the radio frequency. 5 seconds after showing the frequency, the LED display will
change to show the current time.
2. Press TIME SET/PRO button (2) button once repeatedly to cycle through the preset stations.
The sequence of loading preset station is:
F01 > F02 > F03 > F04 > F05 > F06 > F07 > F08 > F09 > F10 > F01 > F02 > ... and so on (repeatedly)
Very Important Note: Please do NOT hold (press continuously) the TIME SET/PRO button (2) in this stage. If
this is done by mistake, the unit will enter into the station preset setup mode with the preset number flashing.
If you do not intend to overwrite your original preset station, do not press any button until the LED display
stops flashing.
E. DUAL ALARM FUNCTION
This product features convenient dual alarms. Each alarm function can be set independently, with a choice of
Wake To Radio or Wake To Buzzer. If either alarm is set to Wake To Radio, please remember to select the desired
band, station and volume level before turning off the radio.

ALARM SETTING

1. To set the alarm time, the Radio must be turned off. To turn it off, press and hold the RADIO ON/RADIO OFF
Button (7).
2. Press the AL1/VOL- button (5) once. The alarm time will display and flash and either Alarm 1 Buzzer indicator
(11) or Alarm 1 Radio indicator (12) will also light up.
3. Press the HOUR/TU- button (3) to set the hour. Press the MIN/TU+ button (4) to set the minute.
4. After setting the desired alarm time, press AL1/VOL- button (5) again, or simply wait for 5 seconds. The
display will return to the current time and the alarm time is saved.