Radio Operation - CAPTELEC PCR-2228 Mode D'emploi

R 2228 / PCR-2228
3. Press the HOUR/TU- button (3) to set the hour.
4. Press the MIN/TU+ button (4) to set the minute. Press and hold the button to scroll through the numbers
quicker.
5. After setting to the correct time, either press TIME SET/PRO button (2) once, or just leave it for 5 seconds.
When the display stops flashing, the clock will start running from the set time.
6. To change the current time, the Radio must be switched off – to turn it off, press and hold the RADIO
ON/RADIO OFF Button (7). Press and hold TIME SET/PRO button (2) for 1 second until the display flashes,
then follow the steps 3, 4 & 5 above to set the new time.
7. To see the seconds, press TIME SET/PRO button (2) once. After 5 seconds, the display will change back into
the current HH:MM time.
PROJECTION MODE
Press Projection mode button (8) once to turn on projection clock. Press once again to flip the projection clock
image reversely. Press once again to turn off the projection clock. Adjust focus knob (16) to adjust the focus on
projection clock image until clearly show on the ceiling or on the wall.
HIGH-LOW DIMMER
Press the HIGH-LOW DIMMER/DST Switch (1) repeatedly to switch the display brightness from
HighMediumLow.
DST SWITCH
Depending on your location and whether or not DST (Day Saving Time) is in effect, press and hold the HIGH-LOW
DIMMER/DST Switch (1) to add an hour. The DST Indicator (10) will light up and an hour will be added to the
current time. To return to the original time, press and hold the HIGH-LOW DIMMER/DST Switch (1) until the DST
Indicator (10) turns off.
D. RADIO OPERATION
1. Press the RADIO ON/RADIO OFF Button (7) once to turn on the radio. The radio receives the FM band with
the FM indicator (13) turned on and the LED display showing the frequency. After 5 seconds, the LED display
will change back to show the time.
2. Adjust the volume by pressing AL2/VOL+ button (6) to increase or pressing AL1/VOL- button (5) to decrease.
Note: Volume range: 00 (mute) to 15 (maximum), 8 level preset as a default.
3. Use the HOUR/TU- button (3) or MIN/TU+ button (4) to tune into the desired station by either of the 2
following methods:
- Manual Tuning : Press either of the 2 tuning buttons, HOUR/TU- button (3) or MIN/TU+ button (4),
repeatedly until the desired station is reached.
The radio can tune from 87.5 MHz to 108 MHz, each press of the HOUR/TU- button (3) can tune down by 0.1
MHz and MIN/TU+ button (4) can tune up by 0.1 MHz.
- Auto Scanning: Press and hold either of the 2 tuning buttons, HOUR/TU- button (3) or MIN/TU+ button (4)
for more than 2 seconds to start auto scan. Scanning will stop automatically when a clear radio signal is
found. Repeat the same procedure by using the same button until your desired station is found.
* To stop auto scanning, press any button once
Note: In some area where the radio signal is not strong enough, the scanning process may not be able to
stop automatically in the desired station. In such case, please use the Manual Tuning method to tune to the
desired station according to instruction above.
4. To turn off the radio, press and hold the RADIO ON/RADIO OFF Button (7) until the radio is turned off and the
LED display shows the time. Under this status, the FM indicator (13) should be off.