Télécharger Imprimer la page

Wolf E Série Instructions D'installation page 11

Masquer les pouces Voir aussi pour E Série:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

I N S TA L L AT I O N
I N S T R U C T I O N S
E S E R I E S
B U I LT- I N D O U B L E OV E N S
S TA N D A R D I N S TA L L A T I O N
IMPORTANT NOTE: For standard installations,
a minimum 610 mm of usable cabinet depth is
required, or the back panel of the cabinet may
need to be removed for proper installation.
The electrical box must be flush with the back
panel of the cabinet.
For standard installations, the E Series built-in
oven is installed by inserting into cabinetry
from the front. The oven has a face trim on all
four sides and will overlap stiles and rails. The
trim overlaps 3 mm on the bottom, 8 mm on
the top and 19 mm on each side.
F L U S H I N S E T I N S TA L L A T I O N
IMPORTANT NOTE: For flush inset installa-
tions, a minimum 635 mm of usable cabinet
depth is required, or the back panel of the
cabinet may need to be removed for proper
installation. The electrical box must be flush
with the back panel of the cabinet.
The flush inset installation requires the built-in
oven to be recessed into the cabinet. A
minimum 838 mm wide and 635 mm deep
cabinet is needed if you want the front of the
oven to be flush with surrounding cabinetry.
IMPORTANT NOTE: For flush inset installa-
tions, the inside edges of the rough opening
must be finished, as they will be exposed
when the oven doors are open. These edges
should be stained instead of having a lami-
nated surface, to avoid damage from high
temperatures during self-clean.
11

Publicité

loading

Ce manuel est également adapté pour:

Icbso30-2f/sIcbso30-2u/s