Safety Standards; Safety Instructions - Klarstein 3MC Mode D'emploi

EN
24

SAFETY STANDARDS

This appliance has been designed and manufactured to conform to the highest
standards of safety and performance including electromagnetic compatibility (EMC).
This appliance conforms to the applicable requirements of the following:
This appliance meets the requirement of Medical Device
Directive 93/42/EEC for medical appliances.
EMC information
• Warning: Use of this appliance adjacent to or stacked with other device should be
avoided because it could result in improper operation. If such use is necessary, this
appliance and the other device should be observed to verify that they are operating
normally. If the appliance does not light on or fl ickering, it means that the appliance
is not operating normally.
• Warning: Don't near active HF surgical equipment and the RF shielded room of an
ME system for magnetic resonance imaging, where the intensity of EM disturbances
is high.
• Warning: Do not change any cable without authorization of the manufacturer.
Use of cables other than those specifi ed or provided by the manufacturer of this
appliance could result in increased electromagnetic emissions or decreased
electromagnetic immunity of this appliance and result in improper operation.
• Warning: Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than 30 cm to
any part of this appliance, including power cable. Otherwise, degradation of the
performance of this equipment could result.
• If the appliance does not light on or fl ickering due to the electromagnetic
disturbances, do not use it and try to place the appliance in other location.
• For maintaining the basic safety and essential performance with regard to
electromagnetic disturbances for the expected service life, please precaution to
take if the use location is near (e.g. less than 1,5 km from) from AM, FM or TV
broadcast antennas

SAFETY INSTRUCTIONS

• Do not use the lamp in damp places.
• Before use, remove all packaging parts and check the device for
Damages. If you are unsure, contact customer service.
• The device may only be used by suitable persons.
• Children should be supervised during use. This lamp is not a toy.
• You do not need any special training for this machine.
• Keep the power cord away from heat and open fi re.
• The minimum distance between the lamp and fl ammable objects must be 1m.