WOLFF 015621 Mode D'emploi page 5

Operating Manual
Angle Cutter (2)
Read before use and keep safe
1.0 Accessories:
Replacement blade, 6 pcs. p.u.
2.0 For cutting a bevelled edge on PVC-tiles and
designer floorings
The angle cutter cuts a bevelled edge of 25° on PVC-tiles and
designer floorings. Thus you reproduce a bevelled edge after
cutting a flooring. The angle cutter produces an exact cut.
The cutting depth is adjustable. Thus the cutter is adaptable to
any type of flooring.
3.0 Guide for removing the breakage edge
The guide for removing the breakage edge is used for bevelling
the back side of a flooring. This is useful with floorings that are
scribed, and that are not cut but broken.
With the angle cutter you remove the breakage edge.
4.0 Blade adjustment
The blade of the angle cutter is factory pre-set. Check the cut
before starting work.The blade is positioned with 2 screws: the
fixing screw (2) and the adjustment screw (3).
The fixing screw holds the blade in the adjusted position. The
adjustment screw sets the width of the bevelled edge. The key
necessary for fixing is enclosed.
5.0 Adjusting the blade
loosen fixing screw (2)
adjust the width of the bevelled edge with adjustment
screw (3)
tighten fixing screw (2) again
Note: do not tighten fixing screw (2) too much, this might deform
the tool.
FasTrimmer, Artikel-Nr. 015621, FasTrimmer (2) Artikel-Nr. 015623
04/2005
Item-No. 15625
English
Item-No.
(1)
(3)
25°
width of bevelled edge
015623
(2)
5