Accessories; Blade Adjustment - WOLFF 015621 Mode D'emploi

Operating Manual
Angle Cutter
Read before use and keep safe
(1)
(3)
25°
width of bevelled edge
FasTrimmer, Artikel-Nr. 015621, FasTrimmer (2) Artikel-Nr. 015623
04/2005

1.0 Accessories:

Replacement blade, 6 pcs. p.u.
Guide for removing the breakage edge
2.0 For cutting a bevelled edge on PVC-tiles and
designer floorings
(2)
The angle cutter cuts a bevelled edge of 25° on PVC-tiles and
designer floorings. Thus you reproduce a bevelled edge after
cutting a flooring. The angle cutter produces an exact cut.
The cutting depth is adjustable. Thus the cutter is adaptable to
any type of flooring.
3.0 Quick-guide
The quick-guide (1) is used for fast cutting or for cutting with the
flooring already laid into the adhesive.

4.0 Blade adjustment

The blade of the angle cutter is factory pre-set. Check the cut
before starting work. The blade is positioned with 2 screws: the
fixing screw (2) and the adjustment screw (3).
The fixing screw holds the blade in the adjusted position. The
adjustment screw sets the width of the bevelled edge. The key
necessary for fixing is enclosed.
5.0 Adjusting the blade
loosen fixing screw (2)
adjust the width of the bevelled edge with adjustment
screw (3)
tighten fixing screw (2) again
Note: do not tighten fixing screw (2) too much, this might deform
the tool.
English
Item-No.
Item-No.
Item-No.
015621
15625
15622
4