SEVERIN AH 7910 Mode D'emploi page 10

for a long period of time, the capacity of
the battery may decrease by a certain
amount. However, full capacity will be
restored after several charge/discharge
cycles.
12 V operation
∙ Insert the small plug of the connecting
cable into the 12V jack of the vacuum
cleaner, and the larger plug into the car's
cigarette-lighter socket.
∙ Power to run the cleaner will now be
supplied directly from the car's electrical
system, but charging the battery is not
possible in this mode, and the charging
indicator will not light up.
Picking up liquid matter
Before picking up liquid matter, ensure that
the rubber nozzle is fully inserted in the
suction aperture.
Crevice tool
The crevice tool can be inserted into the
suction aperture to clean crevices, corners
and other areas diffi cult to reach.
Crevice brush
The crevice brush can be fi tted to the crevice
tool and is suitable for cleaning uneven
surfaces such as computer keyboards etc.
Operation
∙ Remove the vacuum cleaner from its wall
bracket.
∙ If required, fi t any of the nozzle
attachments to the suction aperture.
∙ Switch on the appliance using the On/Off
switch.
∙ Always ensure that the dust container is
emptied in good time, before the dust or
10
liquid matter collected reaches the level of
the inner suction tube.
∙ Should you experience a decrease in
vacuuming power during operation, switch
off the appliance and recharge. Always
ensure that the appliance is switched
off before putting it in the charging
station.
Cleaning
General
∙ Before cleaning the appliance, remove
the vacuum cleaner from the wall bracket.
∙ To avoid the risk of electric shock, do not
clean the appliance or the adapter with
water and do not immerse them in water.
∙ If necessary, the housing may be wiped
with a damp cloth. Wipe dry afterwards.
To empty the dust container
Reduced vacuuming power despite a fully
charged battery pack indicates that the dust
container and fi lter inlay must be emptied.
∙ Hold the vacuum cleaner with the dust
container facing downwards.
∙ Push the release button, open the dust
container in a downward and forward
direction, remove the fi lter and empty it.
∙ The fi lter can be cleaned by slightly
tapping it or by using a brush. The fi lter
can be separated from its holder by
simply pulling it out of its guide.
∙ Should the fi lter be visibly dirty, it should
be thoroughly cleaned with soapy
water; make sure to let it dry completely
afterwards.
∙ The fi lter holder, dust container and
attachment tools may be cleaned the
same way.