Kuppersbusch IKE325-0-2T Notice D'utilisation page 26

26
On the opposite side:
1. Install the lower pin.
2. Install the lower door.
3. Refit the pins (B) and the spacers (C) on
the middle hinge on the opposite side.
4. Install the upper door.
5. Tighten the spacer and tighten the up-
per pin.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
C
B
C
Installing the appliance
Caution! Make sure that the mains
cable can move freely.
Do these steps.
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
2. Drill the hinge cover A, as shown in fig-
ure.
Apply the covers A and A1 (in the bag)
in to the intermediate hinge.
A
50 - min. 200 cm
2
x
min.
200 cm
2
x
A1