Cooper Lighting Solutions Galleon Directives D'installation page 4

Installation Instructions – Galleon LED
Photocontrol Orientation (If Equipped)
N otee: The orientation procedure is only required for
photocontrols which specifically require the
cell to be aimed north. Otherwise pre-selected
factory orientation will function properly. Follow the
directions recommended by the photocontrol supplier
for proximity to light sources. Lighted signs, building
surface reflection, floodlights,
tree branches, etc. may affect final position of
the photocontrol.
1. Loosen the two screws to allow rotation of the
receptacle.
2. Insert screwdriver into center slot and rotate
receptacle until indicator arrow points north.
3. Retighten screws.
4. Insert the photoelectric control (or shorting cap) into
receptacle and twist into locked position.
N otee: The photocontrol (not included) must contain
a soft, resilient gasket fastened to the bottom
surface to assure a proper weather seal between the
control and the receptacle.
Bi-Level Switching (If Equipped)
For Bi-level switching, the input leads to the fixture
will be independently labeled to indicate dimming
preferences as appropriate (as defined by the order
requirements). Two separate supply lines of line voltage,
neutral and ground must be connected to the fixture leads
to enable the bi-level switching functionality of the fixture.
Maintenance
A regular maintenance schedule should be followed to
retain optimal light output and thermal performance. Optical
lens cleaning should be performed with a clean dry cloth to
remove any dust or other contaminants. Additional cleaning
can be performed with non-abrasive acrylic cleansing
solution.
4
COOPER LIGHTING SOLUTIONS
IB500011EN Installation instructions