Before Setting Up Your Tv - Sony BRAVIA KDL-48W700C Manuel De Référence

Before setting up your TV

Some TV models are packaged with a detached Table-Top
Stand so you can mount your TV to a wall right away. See
page 17 (Installing the TV to the Wall) if you want to mount
the TV to a wall.
If you are not mounting the TV to a wall, you will need to
attach the Table-Top Stand. You will need a Phillips
screwdriver (not supplied) and the supplied screws to
complete the task. Look for the supplied Startup Guide.
Be sure to consider the following while setting up your TV:
• Disconnect all cables when carrying the TV.
• Carry the TV with the adequate number of people; larger
size TVs require two or more people.
• Correct hand placement while carrying the TV is very
important for safety and to avoid damage.
• Ensure your TV has adequate ventilation, see page 19.
• For best picture quality, do not expose the screen to direct
illumination or sunlight.
• Avoid installing the TV in a room with reflective wall and
floor materials.
• Avoid moving the TV from a cold area to a warm area.
Sudden room temperature changes may cause moisture
condensation. This may cause the TV to show poor
picture and/or poor color. Should this occur, allow
moisture to evaporate completely before powering the TV
on.
• Ensure that there are no objects in front of the TV.
IR Sensor
Recommended Measures to Secure the
TV
Consider the following measures when securing your TV to
a Stand (not supplied).
1
Secure the Stand for the TV.
Make sure the Stand can adequately support the weight
of the TV. Use two angle braces (not supplied) to secure
the Stand. For each angle brace use the appropriate
hardware to:
• Attach one side of the angle brace to the wall stud.
• Attach the other side to the Stand.
4
US
Angle braces
(not supplied)
Stand
2
Secure the TV to the Stand.
Use the optional hardware listed as follows (not
supplied):
• M6 machine screw (screwed into the TV's rear cover)
• A screw or similar (attach it to the Stand)
• Rope or chain (strong enough to support the weight of
the TV). Make sure that there is no excess slack in the
rope or chain.
Screw hole on the rear cover
The length of the M6 machine screw differs depending
on the rope or chain diameter. Please see below
illustration.
8-12 mm
Screw M6
Rope or chain
TV's rear cover
M6
machine
screw (not
supplied)
Rope or chain
(not supplied)
Screw
(not supplied)