Steam Cleaning Hard Floors - Hoover TwinTank WH20200 Guide D'utilisation

usinG the solution ContRol dial and adjustinG the solution
„ The Solution Control Dial controls the amount of cleaning solution that is added to the steam. It does
not adjust the amount of steam, only the cleaning solution.
„ If you wish to clean with steam alone, simply turn the Solution Control Dial to "STEAM ONLY". Now
every time you press the Steam Trigger, you will release steam alone.
„ If you wish to clean using cleaning solution, simply turn the Solution Control Dial to the desired
setting. Now when pressing the Steam Trigger, the steam mop will release the amount of cleaning
solution that is indicated on the Solution Control Dial as well as a steady flow of steam.

steaM CleaninG haRd FlooRs

WARNING
!
Never leave the Steam Mop in one spot on any
surface for an extended period of time with a
damp or wet Microfiber pad attached as this
may damage the floor surface.
When cleaning hard floors, your Steam Mop
should only be used on tiles, linoleum, sealed
hardwood flooring, engineered hardwood,
laminate, vinyl, and sealed stone floors. If used
on waxed flooring, you may experience loss of
glossiness.
To reduce the risk of personal injury, unplug the
steam cleaner when assembling the accessories.
Do not clean over floor electrical outlets.
Do not use steam cleaner or press the Steam
Trigger without water in the water tank.
IMPORTANT
Never use the Steam Mop without the
Microfiber pad properly attached to the Mop
Head.
„ Attach Microfiber pad. Plug in and press the
power button on the steam cleaner (2.13).
„ The steam cleaner will take roughly 30
seconds to be ready to produce steam.
Once steam is ready to be produced, the
green "steam ready" indicator will illuminate.
„ To recline the steam cleaner place foot on
Mop Head and gently pull handle backwards
(2.14).
„ To produce steam squeeze the Steam Trigger
(2.15).
„ Move the Steam Mop slowly backwards and
forwards across the floor (2.16) paying
particular attention to high traffic areas.
2.13
!
2.15
to disinfect hard surfaces
„ Use steam alone. Do not use cleaning
solution. Turn Solution Control Dial to "STEAM
ONLY".
„ Connect the hard floor Microfiber Pad (see
2.6, A) and run a minimum of 4 strokes at a
medium pace (5-7 seconds per 32" stroke)
across same area. Allow to air dry.
8
2.14
2.16