TROUBLESHOOTING
WARNING:
Always remove the safety key and battery pack when servicing or transporting the mower. Always
protect your hands by wearing heavy gloves or wrapping the cutting edges with rags or other materials when
performing any maintenance on the mower blade.
CAUSE
PROBLEM
◾
The battery pack is depleted.
◾
The battery pack is not mounted in place in
the battery compartment.
◾
The battery or mower circuitry is too hot.
(The power indicator on the mower will
illuminate in orange for 10 seconds)
The mower fails
◾
The side rails are not extended to their
to start
maximum length and the clamps are not
locked in position.
◾
The handle is not set at one of the three
operating positions.
◾
The mower deck is clogged with grass and
debris.
◾
The blade is dull.
◾
The cutting height is not set properly.
The mower cuts
unevenly
◾
The blade is assembled incorrectly.
◾
The battery pack is depleted.
◾
Mower is in overload condition.
◾
Mower deck is clogged with grass and
debris.
The mower stops
while mowing
◾
The battery or mower circuitry is too hot. (The
power indicator on the mower will illuminate
orange for 10 seconds.)
◾
The side rail is retracted a little by the
pushing force applying on the handle.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2020E / LM2020E-SP
SOLUTION
◾
Charge the battery pack.
◾
Attach the battery pack to the
mower; press it until you hear a
click.
◾
Allow the battery pack or mower
to cool until the temperature drops
below 67°C.
◾
Fully extend the handle and lock
both clamps.
◾
Adjust the handle to one of the three
operating positions.
◾
Clean the mower deck and make
certain that the blade has freedom
of movement.
◾
Sharpen or replace the blade.
◾
Raise the deck to a higher cutting
height setting.
◾
Reassemble the blade, following the
section "INSTALLING THE BLADE" in
this manual.
◾
Charge the battery pack.
◾
Raise the cutting height or slow down
the mowing.
◾
Unclog the mower deck. Raise
the cutting height, or cut a narrow
swath.
◾
Allow the battery pack or mower
to cool until the temperature drops
below 67°C.
◾
Unlock the clamps. Fully extend the
side rails and lock the clamps again.
EN
17