emerio FN-112031 Mode D'emploi page 5

FN-112031 / FN-112031.1
PARTS DESCRIPTION
1. Grille clamping ring
2. Front guard
3. Blade fastening screw
4. Blade
5. Guard fastening screw
6. Rear guard
7. Motor shaft
8. Oscillation knob
9. Timer
10. Speed control buttons
11. Fixing bolt
12. Hight adjustment pipe
13. Fixing ring
14. Standing shaft
15. Standing base
ASSEMBLY INSTRUCTIONS
** Please assemble correctly by the following order when using.
1. Assembly of the stand
Put the standing shaft (14) onto the standing base (15). Use the fastener (screwed off from the standing

shaft) to fix the standing shaft onto the standing base.
2. The whole assembly
Pull the height adjustment pipe (12) out and tighten the fixing ring (13).

Connect the fan main body and the height adjustment pipe (12) together by the fixing bolt (11) and then fix

them.
3. Rear grille assembly
Unscrew the blade fastening screw (3) in clockwise direction and unscrew the guard fastening screw (5) in

anti-clockwise direction.
Fix the rear guard (6) onto the motor front shell.

Screw the guard fastening screw (6) tightly in clockwise direction.

4. The assembly of fan blade
Place fan blade (4) onto motor shaft (7) ensuring the blade fits properly with the shaft pin.

Tighten the blade fastening screw (3) onto the motor shaft in anti-clockwise direction to fix the blade.

5. Front grille assembly
Use the grille clamping ring (1) to attach the front guard (2) onto the rear guard. Tighten the screw on the

ring to fix the connection of front guard and rear guard.
- 4 -
EN