35
Descaling with the BEEM Premium Descaler Concentrate
1. Fill the water reservoir (7) up to the MAX marking with a concentrate/water solution of
no more than 1:20 (one part concentrate to 20 parts water).
2. Move the On / Off switch (8) on the side of the water reservoir to the I (On) position to
switch on the device. The operating lamp in the On / Off switch lights up.
3. Turn the thermostat control (9) clockwise until it resists to switch on the device. The
control lamp (11) lights up. The solution starts boiling.
4. As soon as the solution comes to a boil, turn the thermostat control counter clockwise
so that the control lamp goes out (see the "Preparation" chapter | "Interval Boiling").
Let the solution take effect for a little while.
5. Allow the solution to run through the discharge tap (12) so that it is also freed of any
limescale residues (see the "Operation" chapter | "Operating the Discharge Tap").
6. To rinse the device, allow two tankfuls of clear water to run through it. The device is
now descaled and ready to be used again.
Storage
Disconnect the device from the mains power when it is not going to be used for a
prolonged period. Clean the device again (see the "Cleaning and Care" chapter) to avoid
possible mould formation. Mould can cause spots and damage on the device that can no
longer be removed / repaired. Allow the device and all accessories to dry completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from
direct sunlight and cannot be accessed by children or animals.
Disposal
Dispose of the packaging material in an environmentally friendly manner and
take it to a recycling centre.
Dispose of the device in an environmentally friendly manner at a recycling
centre for used electrical and electronic devices. It should not be disposed
of in the normal household waste. More information is available from your
local authorities.
05407_DE-EN-FR-NL_A5_V1.indb 35
05407_DE-EN-FR-NL_A5_V1.indb 35
EN
27.11.2017 16:54:15
27.11.2017 16:54:15