Adjusting Speaker Volume; Adjusting Ringer Volume; Troubleshooting - Genther ClearOne Guide De L'utilisateur

Adjusting Speaker Volume

When your ClearOne is on, you can
make the speaker volume louder or
softer using the keypad. It works the
same way that a television remote
works to change the volume of a
television.
To adjust the speaker volume:
1. If your ClearOne is off,
ON OFF
turn it on by pressing the
ON/OFF button.
2. Use one of the following methods to
change the volume:
• To change the speaker
volume one step at a time,
press and release the right or left side of
the volume button. The speaker
volume gets louder or softer by one
step. The status lights change to
indicate the new volume.
• To run the speaker volume up or
down, press and hold the right or left
side of the volume button. The speaker
volume gets continuously louder or
softer. The status lights change to indi-
cate the new volume. The status lights
run clockwise for louder and counter-
clockwise for softer.
If you set the speaker volume to the
highest or lowest setting, the lights stop
moving and the volume does not
change.
14

Adjusting Ringer Volume

You change the ringer volume the same
way you change the speaker volume,
except you do it with your
ClearOne turned off.
To adjust ringer volume:
1. If your ClearOne is on,
ON OFF
turn it off by pressing the
ON/OFF button.
2. Use one of the following methods to
change the volume:
• To change the ringer
volume one step at a time,
press and release the right or left side of
the volume button. The ringer volume
gets louder or softer by one step. You
hear the new ring from the speakers.
The status lights change to indicate the
new volume.
• To run the ringer volume up or
down, press and hold the right or left
side of the volume button. The ringer
volume gets continuously louder or
softer. The status lights run clockwise
for louder and counterclockwise for
softer.
If you set the ringer volume to the
highest or lowest setting, the lights stop
moving and the volume does not
change.

Troubleshooting

If you are having trouble with your
ClearOne, it may not have been set up
properly or other equipment might be
malfunctioning. To begin, check for the
following or consult the chart on the
next page:
• The ClearOne power supply is
plugged into a 120-volt electrical outlet
and its power light is on.
• The base connector cable from the
power supply to the ClearOne base
unit is securely connected.
• The telephone cord from the power
supply is securely connected to the
telephone wall jack.
• The equipment the other party is
using is comparable in quality to your
ClearOne Conference Phone and is
working properly.
15