Important operating guidelines
~
Batteries - SIM - Emergency calls - SAR - Repairs
1.
To increase the life of your battery, only use WIKO
chargers and batteries. Replacing the battery with
a non-compliant model may result in the latter
exploding.
2.
Never throw batteries on a fire and follow the
guidelines in force for recycling used batteries and
phones.
3.
Be careful not to crush or damage the battery,
as this could cause an internal short circuit and
overheating.
4.
Do not take the battery apart.
5.
The battery can be recharged several hundred times
before needing to be replaced. When it shows signs of
losing its power, it can be replaced.
6.
If you do not use your mobile phone for an extended
period, remember to recharge the battery to optimise
its use time.
7.
Do not throw batteries away with household waste:
recycle them in accordance with the manufacturer's
guidelines. If the battery is damaged, contact the
after-sales service or the nearest authorised WIKO
dealer.
8.
Unplug the charger from the wall socket when the
battery is fully charged in order to reduce your energy
consumption.
9.
Do not leave the battery being charged for more
than a week as this might result in an overload and
reduce the life of the product.
10.
Handle the SIM cards with care: wipe them with a
soft cloth if they appear dirty.
11.
Emergency calls: the emergency numbers may
not be accessible on all mobile telephone networks,
in isolated areas or areas where there is no coverage;
check first with your operator.
12.
Radio Frequency Exposure :
Your mobile phone has been designed and
manufactured in accordance with the international
guidelines (ICNIRP
1
) on exposure to radio frequencies.
These guidelines, which are based on various studies
and research, have been developed by independent
scientific organisations to ensure the safety of
everyone who uses a mobile phone.
The safety information on exposure to radio waves
uses a unit of measurement known as SAR (Specific
Absorption Rate). The international guidelines have
set this limit at 2W/kg*. The phone is used in standard
operating positions when being tested for its SAR.
1
International Commission on Non-Ionising Radiation
Protection
Although the SAR is determined using the highest
power level, the phone's real rate of specific
absorption whilst in operation may be well below the
maximum value.
A phone is designed to operate at different power
levels so that it only uses the power it needs to be
connected to the network.
In addition, all models of phone must undergo tests
before being marketed to ensure compliance with the
European R&TTE directive.
This directive publishes strict rules for guaranteeing
the safety of users and for preventing any risks to
health.
The maximum SAR value tested on this device when
used in its normal position at the ear is 0.351 W/kg and
0.584 W/kg when used close to the body, at a minimum
distance of 1.5 cm. It complies with the rules on
exposure to radio frequencies when used in its normal
position at the ear or at a minimum distance of 1.5 cm
from the body. The device uses a high-quality network
connection for transmitting files, data and messages.
On occasion, the transmission of files or messages
may be delayed until the connection is available. When
this is the case, be sure to follow the instructions
regarding the separation distance for establishing
the transmission. If you use a case, belt-clip or holder