Table des Matières
Publicité
ENGLISH
Description and use
The product you have purchased is an infrared
remote control for remote operation of Vortice NOR-
DIK ECO series reversible ceiling fans.
Installation with rods 290÷915
Fig. 1 - 9
Installation with rod 160
Fig. 10 - 29
Operation
CAUTION!!!
Switch off the potentiometer if present to use the
TELENORDIK ECO.
TELENORDIK ECO features
Fig. D
0 Shut-down
1 – 5 On / Speed adjustment
(minimum 1 – maximum 5)
Press the desired speed button to switch
on the product.
"Reverse" mode operation
"Ventilation" mode operation
Timer:
Mode 1- Press the button 1 time. The LED will light
up and two short beeps will be emitted. The
product will operate for a half hour.
Mode 2- Press the button 2 times. The LED will light
up and three short beeps will be emitted.
The product will operate for one hour.
Mode 3- Press the button 3 times. The LED will light
up and four short beeps will be emitted. The
product will operate for an hour and half.
Mode 4- Press the button 4 times. The LED will light
up and five short beeps will be emitted. The
product will operate for two hours.
The LED will stay on for the duration of operation. It
will automatically switch off after the programmed
time expires, simultaneously with the emission of a
long beep and product shut-down.
If the product is already running on a timer, each
press of the button after a short beep will re-pro-
gram product operation for the entire time duration
of the next mode.
If the product is running on a timer and the "0" shut-
down button is pressed, the product will shut off but
the timer will continue to run. When the power is
switched on again, press the desired speed button
and the product will run for the remaining previously
selected timer mode (if it has not yet expired) and
will automatically switch off after the set time has
elapsed, along with a long beep and LED shut-
down.
Light On / Off
5
Publicité
Table des Matières
