Special Safety Instructions; Noise And Vibration - Flex RS 13-32 Notice D'instruction D'origine

RS 13-32 / RSP 13-32
 Use suitable detectors to detect
concealed power supply cables or
consult your local supply company.
Contact with electric cables may result in
a fire and/or electric shock. A damaged
gas pipe may cause an explosion. Cutting
into a water pipe will cause damage to
property or may cause an electric shock.
 When working, hold the power tool firmly
with both hands and ensure that you
have a secure footing. The power tool is
controlled more securely if held with both
hands.
 Keep the workplace clean. Material
mixtures are especially dangerous. Light
metal dust may burn or explode.
 Wait until the power tool has come to
a stop before putting it down. The cutting
accessory may snag, causing the operator
to lose control of the power tool.
 Secure the workpiece. A workpiece is
held more securely in a clamping device
than by hand.

Special safety instructions

 The mains voltage and the voltage speci-
fications on the rating plate must corres-
pond.
 Do not work on materials which release
hazardous substances (e.g. asbestos).
 Identify the power tool with stickers only.
Do not drill any holes into the housing.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The A-weighted noise level of the power tool
is typically:
Sound pressure
level
Sound power
level
Uncertainty K
Total vibration value:
Emission value
a when sawing
h
chipboard
RS RSP
13-32 13-32
dB(A) 89.6 90.5
dB(A) 100.6 101.5
dB 3
2
m/s 10 10.9
Emission value
a when sawing
h
wooden beam
Uncertainty K
ATTENTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE!
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 62841 and may be used to compare one
tool with another. It may be used for a pre-
liminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary to
take into account the times when the tool is
switched off or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and
the cutting accessories, keep the hands
warm, organisation of work patterns.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
RS RSP
13-32 13-32
2
m/s 12.3 10.4
2
m/s 1.5
15