Installation Instructions; Safety Recommendations For Handling And Lifting .29 C Safety Recommendations For Installation; Installation; Mounting The Pump - Annovi Reverberi RS 11.11 N Notice D'utilisation Et Installation

Safety recommendations for installation
Take all possible precautions to allow the pump to be installed in a safe, risk-free manner.
All installation phases must be taken into consideration when designing the machinery or plant in which the
pump is to be installed.
The design must consider all mounting points, the means of transmission of the energy sources, and the
protective and safety devices required by the relevant regulations to prevent the risk of injury.

Installation

The mechanical connection between the pump and the motive power source may be made by means of a
pulley and belt, or a flexible coupling, or through a direct flanged connection to the motive power source.
The crankshaft may turn in either direction.
The water supply connection can be made equally well to the intakes on the right or left of the pump (see diagram).
Only connect the pump to filtered, clean water sources.
Unscrew the plugs fitted on the various ports in the factory by the manufacturer, and screw the plugs onto the
ports not used, depending on connection requirements.
Replace the oil plug (A), used for shipment with the breather plug B) supplied.
D
C
D
C
D
UN003401-CV

Mounting the pump

The pump must be installed on a horizontal surface with no flexible components between it and the mounting
surface.
The illustration shows the maximum permitted pump installation angle beyond which proper lubrication of
the crank mechanism is not ensured.
Secure the pump with screws of suitable diameter and length, fixing them through the holes provided in the
pump body.
max. 5°
max. 5°
UN003411-CV
English

INSTALLATION INSTRUCTIONS

D
C
C
max. 5°
max. 5°
30
A) Temporary oil plug
B) Oil plug with breather
C) Intake port
D) Delivery port
5
Use and Installation