Surface Temperatures; Ambient Temperature; Changing The Temperature Unit - Inventum MT60 Mode D'emploi

Saving the temperatures measured
The temperature last measured, i.e. only the last temperature of a series measured, is saved automatically as soon as the thermometer is
switched off. There are 9 memory locations available for this.
You can call up the last temperature measured with the " " button. The date and time are also shown. The LED dous not support any requests
for stored measured values. If you continue to hold down the " " button, you will enter a special measuring mode, in which the thermometer
will not make a correct measurement. In this event, allow the thermometer to switch off automatically after about 1 minute and then switch on
again.
Surface temperatures
When you want to measure surface temperatures with this infrared thermometer, you must change to the "SCAN" mode. With the thermometer
switched on (standard forehead thermometer mode) keep ther " " button depressed and at the same time press the "SCAN" button. This
mode is indicated with the symbol. If you keep the "SCAN" button depressed, the surface temperature measured is continiously displayed.
You can apply the sensor tip directly to the surface to be measured or measure at close range (do not immerse in liquids). Note that the
temperature displayed is the surface temperature measured but not adjusted. It cannot be compared with the forehead temperature.
Ambient temperature
After the measurement, the thermometer automatically switches to standby mode after about 1 minute, but only if the time has been set. This
mode is identified by the symbol and the ambient temperature is shown continuously. If you want to use the thermometer to measure the
ambient temperature, it should be positioned so that the measurement is not influenced by solar radiation or other influences such as cold
draughts from air-conditioning systems. In addition to the ambient temperature, which is updated once every minute, the date and time are
displayed alternately.
Changing the temperature unit
You can display the temperature in degrees Celsius (°C) or degrees Fahrenheit (°F). With the thermometer switched off or in standby mode, select
the unit by holding down the "SCAN" button and at the same time pressing the " " button. Keep the two buttons depressed until the
temperature unit changes. All stored temperatures are displayed in the temperature unit.
37