Télécharger Imprimer la page

S&P TL-18 PTC Notice D'installation Et D'utilisation page 11

Masquer les pouces Voir aussi pour TL-18 PTC:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Connect the plug into the power point. The heater is a Class II appliance and it does not
require an earth connection.
Select the required power using the power selector and move the thermostat control to
maximum position.
Power selector
O
Stop
Fan (cold air)
Hot air heater (1000W)
●●
Very hot air heater (2000W)
Thermostat
Min.
Once the room has reached the desired temperature, slowly move the control until
there is a soft "click" and the device is disconnected. From this time the heater turns on
and off automatically, keeping the pre-selected comfort temperature.
Note : The LED is illuminated whenever the heater is operating.
4.
Maintenance
Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
Periodically, to prevent an accumulation of dust, clean the inlet and outlet air grilles (Fig
1b-d) with a damp cloth or a vacuum cleaner. Never use petrol or aggressive and/or
abrasive dissolvents to clean the device.
If the air inlet filter is too blocked with dust, remove the screw that fix the rear
grille (Fig.2) and use two plastic flange to remove it.
You can clean the filter with cold water and install it again once completely dry.
Do not immerse the device or spray with water.
If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
5.
Removal from service and recycling
EU regulations and our commitment to future generations oblige us to recycle
used materials; please remember to dispose of all unwanted packaging materials at the
appropriate recycling points, and to drop off obsolete equipment at the nearest waste
management point
Max.
11

Publicité

loading