S&P TL-40 Notice D'installation Et D'utilisation page 14

2. The product
 Description of the product
1 Outlet air
2 LED by overheating
3 Transport handle. (Fig. 1)
4 Inlet air
5 Inlet air filter
6 Extension to increase stability
7 Thermostat
8 Power selector
9 Upper support wall. (Fig. 2)
10 Lower support wall. (Fig. 2)
3. Use and operation
 The heater can be used as a mobile heater or fixed (mounted in a wall).
 Used as a mobile heater: (Figure 1)
The heater must work with the air outlet grille on the top (fig.1-1) and with the extension
to increase the stability, extended (fig.1-6). Be sure to place the unit on a flat and firm
surface.
 Used with fixed mounting in the wall (Figure 2)
The heater must work with the air outlet grille at the bottom (fig.2-1).
Using a drill of Ø6,make the four holes according to the dimensions shown in Figure 3.
Insert the wall plugs and fix the two brackets. (Fig.2-9 / Fig.2-10) using supplied
screws.
Attention: The mounting must follow the installation dimensions given in Figure 4.
IMPORTANT FOR FRANCE:
When the heater is installed on the wall, the electrical connection must be made
according to the image indicated below: cut the cable and use the terminal connection
between the power cable and the power source.
In wet rooms, bathrooms or kitchens, the terminal must be installed at least 65cm
off the ground. The fixed connection can only be made on cable networks that are
equipped with double pole disconnecting device with a contact gap of at least 3 mm in
all poles.
Electricity
 Before connecting the applicance to the network, make sure that the power supply
corresponds to the details listed on the nameplate: 230V ~ 50Hz.
Phase = brown
Neutral = blue
14
Power supply