Safety Instructions - S&P TL-40 Notice D'installation Et D'utilisation

ENGLISH
TL-40
Please read these instructions carefully before using this heater in order to avoid
damage or any dangerous situations arising. Any use of the product other than that
indicated in this manual may cause fire, electrical danger, or injury and will make the
warranty null and void.
The warranty does not cover any defect, deterioration, loss, injury, or damage that is due to
incorrect use of the product. All legal rights in this regard are guaranteed. No warranty condition
can exclude or change the warranty conditions regulated by State laws that may not be
excluded or modified for any reason.
Before doing anything else, remove the packaging carefully and check the integrity of the
product. Should any defects or damage be found, do not use or attempt to repair the equipment,
but contact the dealer.
Do not leave the packaging within reach of children and dispose of the parts in compliance with
current provisions.

1. Safety instructions

Make sure the power supply corresponds to the details

shown on the nameplate: 230 V ~ 50Hz.
This product has been designed as a mobile heater or

wall mounting. It is designed as an auxiliary heat
source and should be used only for this purpose.
Flammable objects (curtains, furniture, plants, etc. )

should not be placed at less than 1 metre from the
appliance.
The heater must not be placed in a recessed place

(under a table, desk, ...) where it interferes with the
free circulation of air, both the inlet and outlet
The heater should not be placed immediately under a

power point.
The heater should be placed such that the power

supply is always available.
11