Standard Equipment; Assembly - RIDGID CROSSCHEK Mode D'emploi

CROSSCHEK

Standard Equipment

The RIDGID ® CROSSCHEK Inspection Sys -
tem comes with the following items:
• CROSSCHEK Inspection System,
(See Figure 1)
• 100' (30m) of Rope,
• Operator's Manual Pack
Figure 1 – CROSSCHEK Inspection System
The CROSSCHEK Inspection Sys -
NOTICE
tem and SeeSnake equip ment is used to in-
spect bores produced by pneumatic under -
ground piercing/bor ing tools. The use of this
system does not guarantee the detection of
cross bores or other bore features. The action of
moving this equipment through the bore may
cause the bore to deform or collapse which
could cause the bore to be unusable or trap
and damage the inspection equipment, requiring
the equipment to be dug up to be removed.
Rope
Pushrod (Not Included)
Shell
Pushrod
Bulb
Wire Rope
Figure 2 – CROSSCHEK Inspection System

Assembly

WARNING
To reduce the risk of serious injury dur-
ing use, follow these procedures for
proper assembly.
1. Make sure to use the correct CROSS-
2
™ Inspection System
3 / " Hex Wrench
32
Camera Head
(Not Included)
Guide
Cone
Adapter
CHEK unit for your system (microDrain
nanoReel, microReel and rM-200). The
diameter and color of the guide will deter-
mine which camera system the CROSS-
CHEK unit can be used on. (See Figure
3.)
microDrain
nanoReel
.62" I.D. .88" I.D.
(22.3 mm)
(15.7 mm)
Black White
Figure 3
2. Securely install the adapter into the cone
(Figure 4 ). The adapter allows attach-
ment of the air hose to the CROSSCHEK
Inspection System. The CROSSCHEK
In spec tion System can then be pulled
through the bore with the air hose, and
the utility (pipe, cable, etc.) can be pulled
back through the bore after the inspection
with the CROSSCHEK In spec tion Sys -
tem. Other adapters can be installed as
long as they have a
for attachment.
Figure 4 – Installing Adapter Into Cone
3. Place the bulb halves around the pushrod
1.5" (38mm) from the end of the camera
spring. Insert and securely tighten the two
screws. The bulb halves should securely
grip the camera pushrod. A small gap be-
tween the halves is acceptable as long
as the pushrod is held securely. Do not
damage the pushrod.
Bulb Half
Camera Spring
Figure 5 – Position Bulb On Pushrod
microReel &
rM200
1.0" I.D.
(25.4 mm)
Black
1 / " NPT male thread
2
1.5"
(38 mm)
™ ,