Installation Instructions For Battery Charger; Mounting The Batter Charger - Dometic 8882040005 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
Frigo
9
Installation instructions for battery
charger
I
NOTE
z The automatic charger can be fitted horizontally or vertically.
z Select a well-ventilated installation location.
z Sufficient ventilation must be available for installation in small, enclosed
spaces.
z The clearance around the automatic charger must be at least 5 cm
z Make sure that the ventilation slots on both the front and back as well as
the rear of the automatic charger are not covered.
z Select an installation surface which is flat and sufficiently firm.
z When selecting the installation location, note the space required behind
the device to allow for fastening in place.
z The 220 volt connection cable must be attached to the automatic charger
so that it cannot free itself, e.g. as a result of vibrations.
z Further information regarding the installation and operation of the auto-
matic charger is available in the accompanying installation and operating
manual
!
CAUTION!
Do not operate the device:
z in wet or damp environments
z in dusty environments
z in the vicinity of flammable materials
z in spaces where there is a danger of explosion
9.1

Mounting the batter charger

➤ Mount the automatic charger using the four brackets included.
16
.

Installation instructions for battery charger

.

Publicité

Table des Matières
loading

Table des Matières