Disposal And Recycling - Matrix EH 500-250-1 Notice Originale

length (4) will be actuated. The motor (14) must
then stop.
• Inspect the mains cable (12) and the control
cable (13) periodically.
• The steel cable (6) and return roller (15) must be
greased every 200 cycles.
• A check must be made every 30 cycles, as
shown in Fig. 4, to find whether the entire steel
cable (6) is in good condition. If it is damaged, it
must be replaced by a steel cable of the type
specified in the technical data.
• Check every 1000 cycles whether the screws for
the fastening bars (1) and return roller (15) are
properly tightened.
• Check every 1000 cycles whether the hooks
(8/16) and return roller (15) are in good
condition.
• Check before using the cable hoist whether the
Emergency Stop switch (9) and pushbuttons (10)
are in perfect working order.
• Check the braking system every 1000 cycles. If
the motor (14) makes any unusual noises or
cannot raise the rated load, it is possible that the
braking system requires an overhaul:
- Replace damaged or worn parts and keep the
service documentation relating to this in a safe
place.
- Please contact an authorized service center for
any unscheduled maintenance work.
9. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 5 and 30 °C. Store the
electric tool in its original packaging.

10. Disposal and recycling

The unit is supplied in packaging to
prevent its being damaged in transit.
This packaging is raw material
and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local
council.
15