Time Display; Adjust (Vga Setting) - Nordmende 20 TFT LCD Mode D'emploi

Time On is deactivated when set is switched off by mains power
REMIND TIME, REMIND PROG.
This is reminder and presently viewed channel gets changed to the remind program number if Remind
prog. is set otherwise only Remind Timer OSD will be displayed during last 10 Seconds of reaching
Remind Timer .
1. Press [CH+] / [CH-] keys on remote or on TV set to select Remind Time / Remind Prog. In Timer
menu.
2. Press VOL+ /VOL keys on remote or on TV set to select Hours and set hours by [CH+] / [CH-] keys
on remote or on TV set in Remind Timer menu. Hours can be set from 00÷23 .
3. Press [VOL+] / [VOL-]keys on remote or on TV set to select Remind Time.
Hours and minutes can be set by direct (0-9) keys on remote.
Press [VOL+] / [VOL-]keys on remote or on TV set to set channel number in Remind Prog menu.
4. Press the [ MENU ] key to confirm. Press the [ MENU ] key to exit.
NOTE :
Remind Time is deactivated and Remind prog. resets to '1' when set is switched off by mains power.

TIME DISPLAY

TIME DISPLAY displays the time set by user as a Current Time.
Press [DISPLAY] key on remote.
Display presents source information with details of input signal connected and Time.
1. Press [VOL+] / [VOL-]keys to set TIME DISPLAY ON/OFF.
9.

ADJUST (VGA setting)

ADJUST function is available only for VGA input and deactivated for other input sources.
(H-Position, V-Position, Auto sync, Phase, Clock) adjust in VGA mode of TV set with personal
computer will be done in VGA Setting menu.
Select the Adjust menu by pressing the [MENU ] and [CH+] / [CH-] keys on remote or on TV set,
press [VOL+] / [VOL-]keys on remote or on TV set to enter into VGA Setting menu.
If picture is not ok it's possibile to adjust H-Position, V-Position, Phase and Clock to adjust the picture.
Auto Sync is for Auto synchronization of LCD TV with PC.
GB
26