Electrical Connection - Kaiser KCT 37 Série Mode D'emploi

KCT 9..., KCT 7... • 400 V • 3N~
KCT 6... • 400 V • 2N~
220 – 240 V
220 – 240 V 400 V 400 V
N N2 N1
KCT 6..., KCT 4... • 220 – 240 V • 2 + 2N~
220 – 240 V
N2
KCT 3... • 220 – 240 V~
N
N2
8
220 – 240 V
L2 L1
220 – 240 V
N1 L2 L1
220 – 240 V
L
N1 L2 L1
L
EN

ELECTRICAL CONNECTION

Before connecting the cooking hob
to the mains power supply, make
sure that:
• the plant characteristics are
such as to follow what is
indicated on the matrix plate
placed at the bottom of the
working area,
• the mains supply has an
efficient ground connection
complying with all applicable
laws and regulations.
Correct grounding is a legal
requirement. If the appliance is not
pre-fitted with a power cable and/ or
plug, use only suitable cables and
plugs capable of handling the power
specified on the appliance's data
plate and capable of resisting heat.
The power cable should never
reach a temperature 50 °C above
ambient temperature at any point
along its length.
If the appliance is to be connected
directly to mains terminals, fit a
switch with minimum aperture of 3
mm between the contacts. Make
sure that the switch is of sufficient
capacity for the power specified on
the appliance's data plate, and
c o m p l i a n t w i t h a p p l i c a b l e
regulations. The switch must not
break the green-yellow earth wire.
The socket or switch must be easily
reachable with the cooking hob fully
installed.
Attention! The manufacturer
declines all responsibility for
damage or injury if the above
instructions and normal safety
precautions are not respected.